Night Optics Falcon 6x Gen 3 Gated Long-Range Night Vision Binocular User Manual
Page 88
2-53
To prevent possible equipment damage, remove
both the goggles and the helmet mount from the
helmet when not required for immediate use. The
strap can remain in place on the helmet.
(2)
If the helmet mount and strap are connected, remove the
helmet mount. To do this, push the release lever at the top center
of the helmet mount and slide the two assemblies apart.
(3)
The strap attaches to the helmet the same as the
original helmet mount. Perform steps in paragraph 2-16 to install
the strap.
NOTE
The strap is now properly attached to the helmet.
(4)
If the helmet has its cloth cover and camouflage strap
installed, it will be necessary to slide the camouflage strap up (at
about a 30
°
– 45
°
angle) at the front of the helmet (see Figure 2-
18).
This step is required in order to prevent the helmet mount from
catching on the camouflage strap when the helmet mount is
installed on the strap.
CAUTION