Leica Geosystems SKI-Pro - Manual (Page 39)

Quick Tour II - Post-Processing 39 Getting Started with SKI-Pro-2.5en
Quick Tour II - Post-Processing
This Quick Tour comprises of the following steps:
Lesson One
Importing GPS raw data
Creating a Project
Lesson Two
Modifying reference coordinates
Processing baselines
Lesson Three
Creating a Coordinate System
Lesson Four
Importing an ASCII file with local coordinates
Lesson Five
Calculating Transformation Parameters
Lesson Six
Using a Coordinate System with a Project
Lesson Seven
Exporting Coordinates to an ASCII file
This Quick Tour is a step-by-step tutorial in which you
learn to post-process GPS data from importing raw data
to exporting final local Grid coordinates.
This exercise assumes that your green soft-
ware protection dongle is connected and the
two options GPS-processing and Datum and
Map are activated.
The exercise comprises of the following scenario:
A rapid static network has been measured. It consists of
the points TP214, B215, TP306, B218 and B313. The
whole network has been measured with two receivers
only. The raw data is given in the directories:
...\SkiPro\Data\SampleData\Sys500\Static\data1
...\SkiPro\Data\SampleData\Sys500\Static\data2.
The local coordinates of the points B215, B218, B313 are
known in UTM Zone 32 North Projection and Bessel
Ellipsoid. The coordinates are given in the file:
...\SkiPro\Data\SampleData\Static\Local.txt
The local grid coordinates of the points TP214 and TP306
shall be derived.