Leica Geosystems SKI-Pro User Manual
Page 59
Quick Tour II - Post-Processing
59
Getting Started with SKI-Pro-2.5en
Lesson Six - Using a Coordinate System with a Project
In this Lesson you will learn how to use a Coordinate
System with a Project and switch between WGS84 and
local coordinates.
If the Project Management is not already open:
From the Management List Bar, select Project
Management.
Right-click on the Project PP Sample and select
Properties.
Click on the Coordinates tab.
The following dialog appears:
Here you can check that the new Coordinate System is
attached to the Project and verify the parameters.
Ellipsoid: Bessel, Map Projection: UTM 32 North and
Transformation: PP Sample WGS-local should now be
displayed.
Click OK to continue.
Right-click on the Project PP Sample and select
Open.
The Project window opens with the last used View active.
Select the Points tab.
The view displays WGS 1984 coordinates in Geodetic
format: