Programming the remote operation id – Panasonic KX-F2781AL User Manual
Page 56
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Programming the remote operation ID
The remote operation ID is used to access the answering device common memory.
Choose any 3-digit number except a number using digits 0 or 7.
Make sure that the first 2-digits of the remote operation ID are different from the junk mail prohibitor ID (page
43) and the mailbox password (page 50).
1
2
3
4
5
6
Press MENU .
Press then Q 0.
SYSTEM SET UP
Dial keypad [MENU]
REMOTE ANS ID
Press START/COPY/SET .
ID=111
CD CD CD
CD CD CD
CD CD CD
<--H-- )<—1
c=> CD CD CD
Enter the desired number.
Press START/COPY/SET .
Press [MENU].
CD»
'6^
'a g
o o o o
O O í
START/COPY/SET
Answering Device Remote Operation
1. Call your unit.
2. Enter the remote operation ID
III during the greeting
message.
3. Press the remote command key
(refer to the right) within 4
seconds.
or
Walt for 4 seconds. All the
recorded messages will be played
back.
Key
Remote Command
0
Skips the greeting message
0
Repeats a message
0
Skips a message
S
New message playback
[s]
All message playback
0
Room monitor
[ZJ
Re-records a greeting message
0
Stops re-recording of a
greeting message
00
Erases a specific message
@0
Erases all messages
00
Message transfer/Pager call ON
00
Message transfer/Pager call
OFF
56