Panasonic KX-F2781AL - Manual (Page 72)

Error messages on the display
If the unit detects a problem, the following messages will appear on the display.
DISPLAY MESSAGE CAUSE & REMEDY
GALT, SERVICE
CHECK COVER
CHECK CRADLE
•There is something wrong with the unit.
Contact your service personnel.
•The back lid is open. Close it.
•The handset and handset cradle have been removed when you connect the
power cord.
—When you want to use the handset and handset cradle, install the handset
cradle correctly (see page 9).
—When you do not use the handset and handset cradle, set the handset switch
to NO HANDSET (see page 65). Then, disconnect and connect the power
cord again.
CHECK DOCUMENT
•The document is not fed into the unit properly. Reinsert the document. If the
misfeeding occurs frequently, clean the document feeder rollers inside the unit
(see page 78). If the problem remains, adjust the feeder pressure (see page 77).
CHECK MEMORY
I-’AX IN MEMORY
• Memory (phone numbers, parameters, etc.) has been erased. Re-program.
•The unit has documents in memory. Install a new recording paper roll (see page
10) or clear the jammed paper (see page 76).
MEMORY FULL
•There is no room left in memory to record a message. Erase some or all of the
messages (see pages 31 and 52).
•The memory is full of received documents. Install a new recording paper roll
(see page 10) or clear the jammed paper (see page 76),
NO RESPONSE
NO TEL GREETING
•The receiving unit is busy or ran out of recording paper. Try again.
•The TEL/FAX greeting message has not been recorded. Record a greeting
message (see page 60).
OUT O F PAPER
PAPER JAMMED
•The unit ran out of recording paper. Install a new recording paper roll (see page
10 ) .
►A recording paper jam occurred. Clear the jammed paper (see page 76).
POLLING ERROR
•The other fax machine does not provide the polling function. Check with the
other party.
REDIAL TIME OUT
•The receiving unit is busy or ran out of recording paper. Try again.
REMOVE DOCUMENT
•The document is jammed. Remove the jammed document (see page 77).
•Attempted to transmit a document longer than 600 mm (23%")- Press the STOP
button and remove the document (see page 77). Divide the document into two or
more sheets and try again.
TRANSMIT ERROR
•A transmission error occurred. Try again.
UNIT OVERHEATED
•The unit is too hot. Let the unit cool down.
72