360 Systems DigiCart/EX - Manual (Page 26)

Memory Card Reader
The Memory Card Reader allows the use of SD memory cards for audio storage. The Card Reader
appears in the system as a Drive at ID 0, with the standard directories numbered 0 to 9, and an S
directory for Stacks.
M EMORY C ARD I NSERTION
Insert the card label side up, with the contacts facing down. Slide it into the card slot until you feel a
slight resistance, then press until the card reaches the end of the slot. The card will return slightly as
you release pressure then remain locked in the Card Reader.
If the card is difficult to insert, check its orientation and try again. DO NOT FORCE THE CARD
INTO THE READER. Objects inserted into the reader may damage it.
A Memory Card must be formatted in the DigiCart/EX before use. See formatting instructions on
page 37. Unformatted cards will display NOT FORMATTED FOR DIGICART and NON-DIGICART
DISK.
Cards formatted in a PC cannot be used unless reformatted in DigiCart/EX, and DigiCart formatted
cards will not be recognized by a PC or other device.
Most memory cards will mount automatically after a short delay. The display will indicate
MOUNTING MEMORY CARD (along with the detected size of the card; this is the total capacity, not
the remaining capacity).
If the card does not mount automatically, press the Stop button to mount the card. The display will
indicate CHECKING FOR MEMORY CARD. If the card is recognized the display will indicate
MOUNTING MEMORY CARD. If the card is not recognized then the display will indicate NO
MEMORY CARD FOUND. This can be caused by a faulty or incompatible card.
If the Card has been formatted the display will show INITIALIZING MEMORY CARD followed by the
contents of Directory 0 or the first directory that contains recordings. Unformatted cards will display
CARD NOT FORMATTED FOR DIGICART.
If a Card is inserted during Record or Playback, it may or may not mount automatically when the
operation is stopped. If not, select Drive 0 and press Stop to mount the card.
M EMORY C ARD R EMOVAL
It is best to remove and insert memory cards only when the DigiCart is idle. REMOVING A CARD
DURING MEMORY CARD PLAYBACK, MEMORY CARD RECORD, COPY OR RENAME
OPERATIONS MAY RESULT IN LOSS OF DATA.
To remove the memory card, press inward lightly until the card reaches the back of the card slot.
Upon release the card will unlatch and should be easily removed from the card slot. DO NOT USE
FORCE TO REMOVE THE CARD, try pressing inward again until the mechanism releases the card.
Wait for the DigiCart to display the message MEMORY CARD REMOVED PLEASE WAIT... before
continuing operation.
If you do remove a card during Playback, DigiCart/EX will lock out selection of the Card Reader
(Drive 0) until after Playback has stopped and a MEMORY CARD REMOVED message has been
displayed.
14
• 24BControl Panel