360 Systems DigiCart/EX - Manual (Page 88)

A BORTED T RANSFER
If you press the
EXIT
or
STOP
buttons on the source DigiCart during a transfer, the transfer will
continue to proceed while the display queries “QUIT TRANSFER? PRESS ENTER/EXIT”
If you press the
EXIT
button, the display will revert to normal and the transfer will continue.
If you press the
ENTER
button, the transfer is aborted and the display briefly shows:
“TRANSFER ERROR, CANCELLED BY USER”
followed by:
“TRANSFER INCOMPLETE, PRESS ENTER/EXIT”
R ECEIVING M ACHINE D ISPLAYS
Display During Transfer
If the receiving DigiCart is idle and the receiver name matches the Destination Name on the source
DigiCart, when a file transfer begins, the display indicates transfer status in the number of files
transferred and percent complete for that file.
When the transfer completes without errors, for a few seconds the display shows:
“TRANSFER COMPLETE, NO ERRORS”
Then the display shows:
“GOOD FILES: NN, BAD FILES: NN”
This indicates the number of files received without errors and the number of files discarded due to
errors. This message will only appear after multi-file transfers.
During Error Occurrence
When an error occurs for a received file, the cause of the error is displayed briefly and the percent
complete display changes briefly to “SKIPPING FILE”
When the transfer is complete, the display will briefly show:
“TRANSFER INCOMPLETE, ERRORS OCCURRED”
Then the display will show:
“GOOD FILES: XX, BAD FILES: XX”
This indicates the number of files received without errors and the number of files discarded due to
errors. Errors in the receiver can be due to:
• A faulty D-NET connection.
• Excessive disk fragmentation causing space allocation time to exceed the time allowed.
• Hardware failure in the receiving unit.
• Errors caused by the transmitting unit will usually be shown on the display of the transmitting unit.
76
• 36BD-Net File Transfer