360 Systems DigiCart/EX - Manual (Page 77)

33BInterface Wiring
• 65
GPI/O Connector Pinout
PIN SIGNAL
1 Play Switch Input
2 Record Switch Input
3 Stop Switch Input
4 Opto-isolator Common Ground
5 +5 Volts
6 Loop Switch Input
7 Pause Switch Input
8 System Ground
9-10-11 No Connect
12 Pause Lamp
13 Loop Lamp
14 Record Lamp
15 Stop Lamp
16 Play Lamp
17 +12 Volts
18 No Connect (Was Secondary Cue Out)
19-25 No Connect
Remote Control
This connection is dedicated to a 360 Systems RC-320 Remote Control with a D-SERIAL-320 Remote
Control interface cable. This port communicates with the remote control and also provides its
power.
PIN SIGNAL
1 GND
2
+5 VOLTS (Not normally used)
3 GND
4
TX + (DigiCart Transmitter, wire to RX+)
5 TX – (DigiCart Transmitter, wire to RX-)
6 Remote Present RTN
7 +12V
8 GND
9 N/C
10 N/C
11
RX + (DigiCart Receiver, wire to TX+)
12 RX - (DigiCart Receiver, wire to TX-)
13 Remote Present signal
14 +12V
15 GND
Remote Bus
This connection is dedicated to 360 Systems RC-210/220 Remote Controls and/or the RC-
210/220/320 Control Bus daisy-chain.