360 Systems DigiCart/EX - Manual (Page 78)

66
• 33BInterface Wiring
PIN SIGNAL
1 GND
2
+5 VOLTS (Not normally used)
3 GND
4
TX + (DigiCart Transmitter, wire to RX+)
5 TX – (DigiCart Transmitter, wire to RX-)
6 HSK OUT (Not normally used)
7 HSK IN (Not normally used)
8 RX + (DigiCart Receiver, wire to TX+)
9 RX - (DigiCart Receiver, wire to TX-)
This connection can also be used as an input for control by automation systems. It should not be
used as an input any time the Remote Control connection is in use such as when an RC-320 is
connected.
Aux Serial Port
This port is dedicated to external third-party serial controllers using either ES-Bus or Peripheral Bus
protocols. Configure this setting in SET AUX PROTOCOL in the SETUP menu.
PIN SIGNAL
1 GND
2
RX - (DigiCart Receiver, wire to TX-)
3 TX + (DigiCart Transmitter, wire to RX+)
4 TX GND
5 N/C
6 RX
GND
7 RX + (DigiCart Receiver, wire to TX+)
8 TX - (DigiCart Transmitter, wire to RX-)
9 GND
Keyboard Port
A PS/2 style connection, any 101-Key or compatible keyboard may be connected.
PIN SIGNAL
1 DATA
2 N/C
3 GROUND
4 +5
V
5 CLOCK
6 N/C
Network Port
This is a 100Base-T standard Ethernet port. Connection is made with an RJ-45 cable connector. Two
LED status indicators are included on the connector. The green LED lights to indicate a valid
network connection. The yellow LED lights to indicate communication activity.
This connection is intended for use only with 360 Systems’ Ethernet Audio Server system. It is not
suitable for connection on a generic LAN or WAN system.