360 Systems DigiCart/EX - Manual (Page 69)

F ADE I N
After you have recorded a cut, you can program a FADE IN. FADE IN always begins at the HEAD
point of a cut, and cannot exceed total cut length or the amount of time between the HEAD point
and the beginning of a FADE OUT or the TAIL. The maximum FADE length is 40 seconds.
When adjusting FADE IN duration, time is measured as the number of seconds from the HEAD point
to the end of the fade. A value of 00:00:00:00:00 equals no Fade In.
NOTE: If you use
PAUSE
during the FADE IN period of the cut’s playback, when
PAUSE
is released
the FADE IN will start over from silence.
Setting FADE IN to a Specific Value
This method allows setting the Fade In length to a known value. This is accomplished without
playing the audio.
• Select a cut and press
EDIT
. Select FADE IN by using selection knob. Press
ENTER
. The
current Fade In duration will be indicated on the display.
• Use the selection knob and navigation arrows to adjust the Fade In duration.
• Press
PLAY
to audition the new Fade In. Repeat the previous steps as needed to adjust the
FADE IN duration.
• Press
ENTER
to save the new Fade In duration, or
EXIT
to close the cut with no change.
Setting FADE IN using Auto-Set
The Auto-Set feature allows setting a new FADE IN end-point during audition. In Edit mode, use the
PLAY
button to start playback and the
STOP
button to set the Fade In duration and stop playback.
• Select a cut and press
EDIT
. Select Fade In by using the selection knob. Press
PLAY
and the
cut will begin playing from the Head point. You will not hear the fade at this time. Press
STOP
to set the new FADE IN end-point location.
• After pressing the
STOP
button, the display will show any previous Fade In end-point on the
top line and the newly selected Fade In end-point on the bottom line. You may use the
selection knob and navigation arrows to adjust the FADE IN end-point value.
• Press
PLAY
to audition the new Fade In. Playback will begin from the Head point and
continue playing until the cut ends or
STOP
is pressed. Repeat the previous steps as needed
to adjust the Fade In time.
• Press
ENTER
to save the new Fade In duration, or
EXIT
to close the cut with no change.
F ADE O UT
After you have recorded a cut, you can program a FADE OUT length. FADE OUT is linear and
always ends at the TAIL point of the cut, and cannot exceed total cut duration. DigiCart/EX limits
FADE OUT length to the time between the end of a FADE IN (if used, otherwise the HEAD point),
and the TAIL point of a cut. The maximum FADE length is 40 seconds.
When adjusting FADE OUT duration, time is measured as the number of seconds from the start of
the fade to the TAIL point. A value of 00:00:00:00:00 equals no Fade Out.
31BAudio Editing
• 57