360 Systems DigiCart/EX - Manual (Page 32)

W AITING FOR NFS
The unit has successfully determined its IP address, either using DHCP or by using a fixed address
assignment. However, if this message persists for more than a few seconds, then the unit was unable
to find a server configured to run the Network File System (NFS) protocol. This service is needed by
DigiCart to access files on the server.
W AITING FOR M OUNT
If this message persists for more than a few seconds, then the current mount path established using
the MOUNT NET DRIVE utility, and saved in the setup file on the DigiCart’s hard disk, could not be
found in the list of exported paths provided by the NFS server.
Either enable NFS sharing on the server for this path, or select a different mount path using the
DigiCart’s MOUNT NET DRIVE utility.
File Navigation User Interface
DigiCart/EX display is divided into three areas. In the upper left area are the lines that show current
machine activity. These two lines also appear on the RC-series remote controls. The upper right
area is used to display context sensitive navigation clues. The lower area is used to display file lists
in the current directory. Using the selection knob you can scroll lists.
N AVIGATION C ONTROLS
You can easily move between the Drive/Directory/Files levels by pressing the
DRIVES
,
DIRS
or
FILES
keys or using the navigation arrow keys. Once a list is selected, use the selection knob to
peruse the list. The current file (or directory or drive) will be displayed in the upper left area of the
LCD.
DRIVES Button
Pressing
DRIVES
activates the drive selection field. The current drive will be highlighted. Use
the selection knob to make a selection.
DIRS Button
Pressing
DIRS
presents the directory selection list. The current directory will be highlighted.
Use the selection knob to make a selection.
FILES Button
Pressing
FILES
will display a list of all files in the current directory. The current file will be
highlighted. Use the selection knob to make a selection.
File Find Function
By using the alphanumeric keyboard, you can instantly find any cut by name or ID. RC-320 users
can find cuts or Playlists by ID number. Cuts in the current directory only require entry of their cut
number or name. However, a search by name will search all directories. You may also find them by
20
• 26BFile Organization and Navigation