KEYENCE GV Series - Manual (Page 10)

10 GV-IM-E
Copyright (c) 2011 KEYENCE CORPORATION. All rights reserved.
11664E 1043-3 96M11664 Printed in Japan
„ Sensor head
*1 Guideline of the amplifier display value when the distance display for the
detection distance is set to "nor".
*2 For GV-H1000, when the response speed is set to 10 ms or less,
Incandescent lamp: 5,000 lx, Sunlight: 3,000 lx
*3 For GV-H1000L, when the response speed is set to 10 ms or less,
Incandescent lamp: 2,500 lx, Sunlight: 1,500 lx
*4 Including the connector cable.
*5 The laser classification for FDA(CDRH) is implemented based on
IEC60825-1 in accordance with the requirements of Laser Notice No.50.
„ Sensor amplifier
*1 11 to 30 VDC when amplifiers are extended.
*2 Including the cable (2 m).
(1) KEYENCE warrants the Products to be free of defects in materials and
workmanship for a period of one (1) year from the date of shipment. If any
models or samples were shown to Buyer, such models or samples were
used merely to illustrate the general type and quality of the Products and
not to represent that the Products would necessarily conform to said
models or samples. Any Products found to be defective must be shipped to
KEYENCE with all shipping costs paid by Buyer or offered to KEYENCE
for inspection and examination. Upon examination by KEYENCE,
KEYENCE, at its sole option, will refund the purchase price of, or repair or
replace at no charge any Products found to be defective. This warranty
does not apply to any defects resulting from any action of Buyer, including
but not limited to improper installation, improper interfacing, improper
repair, unauthorized modification, misapplication and mishandling, such as
exposure to excessive current, heat, coldness, moisture, vibration or
outdoors air. Components which wear are not warranted.
(2) KEYENCE is pleased to offer suggestions on the use of its various
Products. They are only suggestions, and it is Buyer's responsibility to
ascertain the fitness of the Products for Buyer’s intended use. KEYENCE
will not be responsible for any damages that may result from the use of the
Products.
(3) The Products and any samples ("Products/Samples") supplied to Buyer are
not to be used internally in humans, for human transportation, as safety
devices or fail-safe systems, unless their written specifications state
otherwise. Should any Products/Samples be used in such a manner or
misused in any way, KEYENCE assumes no responsibility, and
additionally Buyer will indemnify KEYENCE and hold KEYENCE harmless
from any liability or damage whatsoever arising out of any misuse of the
Products/Samples.
(4) OTHER THAN AS STATED HEREIN, THE PRODUCTS/SAMPLES ARE
PROVIDED WITH NO OTHER WARRANTIES WHATSOEVER. ALL
EXPRESS, IMPLIED, AND STATUTORY WARRANTIES, INCLUDING,
WITHOUT LIMITATION, THE WARRANTIES OF MERCHANTABILITY,
FITNESS FOR A PARTICULAR PURPOSE, AND NON-INFRINGEMENT
OF PROPRIETARY RIGHTS, ARE EXPRESSLY DISCLAIMED.
IN NO EVENT SHALL KEYENCE AND ITS AFFILIATED ENTITIES BE
LIABLE TO ANY PERSON OR ENTITY FOR ANY DIRECT, INDIRECT,
INCIDENTAL, PUNITIVE, SPECIAL OR CONSEQUENTIAL DAMAGES
(INCLUDING, WITHOUT LIMITATION, ANY DAMAGES RESULTING
FROM LOSS OF USE, BUSINESS INTERRUPTION, LOSS OF
INFORMATION, LOSS OR INACCURACY OF DATA, LOSS OF
PROFITS, LOSS OF SAVINGS, THE COST OF PROCUREMENT OF
SUBSTITUTED GOODS, SERVICES OR TECHNOLOGIES, OR FOR
ANY MATTER ARISING OUT OF OR IN CONNECTION WITH THE USE
OR INABILITY TO USE THE PRODUCTS, EVEN IF KEYENCE OR ONE
OF ITS AFFILIATED ENTITIES WAS ADVISED OF A POSSIBLE THIRD
PARTY’S CLAIM FOR DAMAGES OR ANY OTHER CLAIM AGAINST
BUYER. In some jurisdictions, some of the foregoing warranty disclaimers
or damage limitations may not apply.
BUYER'S TRANSFER OBLIGATIONS:
If the Products/Samples purchased by Buyer are to be resold or delivered
to a third party, Buyer must provide such third party with a copy of this
document, all specifications, manuals, catalogs, leaflets and written
information provided to Buyer pertaining to the Products/Samples.
E 1101-3
Specifications
Item Specifications
Model
GV-
H45
GV-
H45L
GV-
H130
GV-
H130L
GV-
H450
GV-
H450L
GV-
H1000
GV-
H1000L
Short-range Mid-range Long-range
Super-Long-
range
Light source
Visible semiconductor laser
Wavelength: 655 nm
FDA
(CDRH)
Part
1040.10 Laser
Class Class Class
1 *5
Class
Class
1 *5
Class
Class
1 *5
Class
Class
1 *5
Output 560 μW 220μW 560μW 220μW 560μW 220μW 560μW 220μW
IEC
60825-1
Laser
Class
Class 2 Class 1 Class 2 Class 1 Class 2 Class 1 Class 2 Class 1
Output 560 μW 220μW 560μW 220μW 560μW 220μW 560μW 220μW
Detection distance
(Amplifier display
value
*1 )
20 to 45 mm
(250 to 0) 55 to 130 mm
(750 to 0) 160 to 450 mm
(290 to 0) 200 to 1000 mm
(800 to 0)
Amplifier
display range
259 to -34 768 to -98 295 to -50 810 to -175
Standard
detection
deviation
0.5 mm 1 mm 3 mm
20 mm (Detection
distance 200 to
800 mm),
30 mm (Detection
distance 800 to
1000 mm)
Spot diameter
Approx. φ 0.1 mm
(Detection distance
45 mm)
Approx. φ 0.3 mm
(Detection distance
130 mm)
Approx. φ 0.8 mm
(Detection distance
450 mm)
Approx. φ 1.8 mm
(Detection distance
1000 mm)
Operation
status
indicators Control output: Red LED
Laser radiation emission indicator: Green LED
Other:
Green LED
Enclosure
rating
IP67
Surrounding air
temperature
-10 to +50°C (No freezing)
Relative
humidity
35 to 85% RH (No condensation)
Incandescent
lamp 10,000
lx 5,000
lx 10,000
lx 5,000
l x 5,000
lx 2,500
lx 5,000 *2
lx
2,500 *3
lx
Sunlight
20,000
lx 10,000
lx 20,000
lx 10,000
lx 10,000
lx 5,000
lx 10,000 *2
lx
5,000 *3
lx
Vibration
10 to 55 Hz,
1.5 mm double amplitude in the X, Y, and Z directions,
2 hours respectively
Housing
Housing material: PBT Packing: NBR
Display: Polyarylate
Metal part: SUS304
Lens cover Glass
Cable
PVC
Cable length 2 m 3 m
Weight *4 Approx. 120 g Approx. 130 g Approx. 190 g Approx. 210 g
Item Specifications
Model
NPN output GV-21 GV-22
PNP output GV-21P GV-22P
Amplifier type Main unit Expansion unit
Power voltage *1 10-30 VDC, Ripple (P-P): 10% max, Class 2
Power consumption
Normal: 2200 mW max. (at 30 V: 73.3 mA max.)
Eco-bar: 1700 mW max. (at 30 V: 56.7 mA max.)
Eco-all: 1600 mW max. (at 30 V: 53.3 mA max.)
Response time 1.5/3/10/20/50 ms
Control output
NPN (PNP) open collector x 2ch, 40 V (30 V) DC max.
Max. 100 mA, residual voltage 1 V max.
Control input
Purple line.... Laser emission stop input
Pink line ....... Setting value bank switching input/
shift input/timing input (selected with
the settings)
Environmental
resistance
Surrounding air
temperature
-10 to +55°C (No freezing)
Relative
humidity
35 to 85% RH (No condensation)
Vibration
10 to 55 Hz, 1.5 mm double amplitude in the X, Y,
and Z directions, 2 hours respectively
Material
Housing material, front sheet: Polycarbonate
Key top:
Polyacetal
Cable: PVC
Weight *2 Approx. 110 g
Env
ironment
a
l resist
an
ce
Sur
rounding light
Material
WARRANTIES AND DISCLAIMERS