Acura 2004 TSX - Owner's Manual - Manual (Page 184)

As required by the FCC:
This device complies with Part 15 of the
FCC rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any
interference received, including
interference that may cause undesired
operation.
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user’s
authority to operate the equipment.
This device complies with Industry
Canada Standard RSS-210.
Operation is subject to the following two
conditions: (1) this device may not cause
interference, and (2) this device must
accept any interference that may cause
undesired operation of the device.
You should erase all three codes
before selling the car.
Select the HomeLink button you
want to train.
Press and hold the HomeLink
button until the red light begins to
flash slowly (approximately 20
seconds).
While continuing to hold the
HomeLink button, place the
remote control for the device 2 to
5 inches from HomeLink.
Release both buttons. HomeLink
should now be trained to operate
the device.
Press and hold the button on the
remote control. Hold both buttons
until the red light begins to flash
rapidly.
To train an already programmed
HomeLink button to operate a new
device:
To erase the codes stored in all three
HomeLink buttons, press and hold
the two outside buttons until the red
light begins to flash, then release the
buttons. 1.
2.
3.
4.
5. Retraining a Button
Erasing Codes
HomeLink Wireless Control System
Comf ort and Convenience Features 181
Main Menu Table of Contents