Acura 2004 TSX - Owner's Manual - Manual (Page 99)

Do not use the seat heaters, even
on the LO setting, if the engine is
left idling for an extended period.
This can weaken the battery,
causing hard starting.
Use the HI setting only to heat the
seats quickly. Select the LO
setting when the seats feel warm.
The HI setting draws large
amounts of current from the
battery.
Follow these precautions whenever
you use the seat heaters:
Both front seats are equipped with
seat heaters. Because of the sensors
for the side airbag system, there is
no heater in the passenger’s seat-
back. The ignition switch must be
ON (II) to use the heaters. Push the
front of the switch, HI, to rapidly
heat up the seat. After the seat
reaches a comfortable temperature,
select LO by pushing the back of the
switch. This will keep the seat warm.
The HI or LO indicator comes on
and remains lit until you turn it off by
pushing the opposite side of the
switch lightly.
In HI, the heater turns off when the
seat gets warm, and turns back on
after the seat’s temperature drops. It
continues to cycle as long as you
leave it set on HI. The HI indicator
remains lit as a reminder that you
have the heater on.
In LO, the heater runs continuously.
It does not cycle with temperature
changes.
Seat Heaters
Instruments and Controls 96
Main Menu Table of Contents