GE C2S985SETSS - Manual (Page 27)

Using the self-cleaning upper oven.
GEAppliances.com
The oven door must be closed and all controls set correctly for the cycle to work properly.
Wipe up heavy soil on the oven
bottom.
DO hand clean
DO NOT hand ^oor frame
Before a Clean Cycle
For the first self-clean cycle, we recommend
venting your kitchen with an open window or
using a ventilation fan or hood.
Remove any broiler pan, broiler grid, all
cookware, probe and any aluminum foil from
the oven—they cannot withstand the high
cleaning temperatures.
NOTE:
■ If your oven is equipped with nickel oven
racks, remove them before you begin the
self-clean cycle.
■ If your oven is equipped with gray porcelain-
coated oven racks, they may be left in the
oven during the self-clean cycle.
Soil on the front frame of the range and
outside the gasket on the front frame will
need to be cleaned by hand. Clean these
areas with hot water, soap-filled scouring
pads or cleansers such as Soft Scrub«: Rinse
well with clean water and dry. Wipe off the
flat inner door and glass with soapy water
and sponge.
Do not clean the gasket. The fiberglass
material of the front frame gasket cannot
withstand abrasion. It is essential for the gasket
to remain intact. If you notice it becoming worn
or frayed, replace it.
Wipe up any heavy spillovers on the oven
bottom.
Make sure the oven light bulb cover is in place
and the oven light is off.
IMPORTANT: The health of some birds is
extremely sensitive to the fumes given off
during the self-cleaning cycle of any range.
Move birds to another well ventilated room.
NOTE: Use caution when opening the upper
oven after the self-clean cycle has ended.
The oven may still be hot.
S elf
C lean
0 0 0 0 0
0 0 0 0 0
S tart
How to Set the Upper Oven for Cleaning
NOTE: The surface burners must be turned
off prior to the self-clean start time.
Touch the SELE CLEAN pad.
NOTE: If the display shows LOC, touch
and hold GAS/CONTROL LOCKOUT pad
for 3 seconds to turn it off on Cafe models
only. Press and hold the 0 and 9 pads for
Profile models only. See the Gas/Control
Lockout section.
Using the number pads, enter the desired
clean time, if a time other than
4 hours is needed.
Clean cycle time is normally 4 hours. You can
change the clean time to any time between
3 hours and 5 hours, depending on how dirty
your oven is.
Touch the START pad.
On models without a door latch, the door locks
automatically. The display will show the clean
time remaining. It will not be possible to open
the oven door until the temperature drops
below the lock temperature and the LOCKED
DOOR light goes o1^.
The oven shuts off automatically when the
clean cycle is complete.
When the LOCKED DOOR light is off, slide
the latch handle to the left as far as it will
go and open the door. If your range does
not have a latch, the door will unlock
automatically.
I The words LOCK DOOR will flash and the
oven control will signal if you set the clean
cycle and forget to close the oven door or
forget to latch the door.
I To stop a clean cycle, touch the CLEAR/OEE
pad. When the LOCKED DOOR light goes
off, indicating the oven has cooled below the
locking temperature, you may open the door.
I Do not use the lower oven drawer during a
self-clean cycle.
27