Using the self-cleaning upper oven, How to delay the start of cleaning, After a clean cycle – GE C2S985SETSS User Manual

Page 28

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Using the self-cleaning upper oven.

The oven door must be closed and all controls set correctly for the cycle to work properly.

S

elf

C

lean

0

0

0

0

E

0

0

0

0

0

CownoL Loam/r

D

elav

S

tart

How to Delay the Start of Cleaning

Make sure the clock shows the correct time of

day.

rj]

On models with Gas/Control Lockout,

touch and hold the Gas/Control Lockout

pad for 3 seconds to turn it off.

NOTE: The surface burners must be turned off

prior to the self-clean start time.

If your model has a latch, latch the door.

01 01 01 0] ®

Touch the Se//^C/eon pad.

H

0

0

0

0

0

S

tart

Using the number pads, enter the desired

clean time.

Touch the Delay Start

pad. The earliest

start time you can set will appear in the
display.

Using the number pads, enter the time of

day you want the clean cycle to start.

~y] Touch the Start

pod.

On models without a door latch, the door locks
automatically. The display will show the start

time. It will not be possible to open the oven

door until the temperature drops below the

lock temperature and the LOCKED DOOR

light

goes off.

d

The oven shuts off automatically when the

clean cycle is complete.

When the LOCKED DOOR

light is off, slide

the latch handle to the left as far as it will

go and open the door. If your range does
not have a latch, the door will unlock
automatically.

I The words LOCK DOOR

will flash and the

oven control will signal if you set the clean
cycle and forget to close the oven door or

forget to latch the door on models with a

latch.

I To stop a clean cycle, touch the Clear/Off

pad. When the LOCKED DOOR

light goes

off, indicating the oven has cooled below the

locking temperature, unlatch the door (on
models with a latch) and open the door.

After a Clean Cycle

You may notice some white ash in the oven.
Wipe it up with a damp cloth after the oven

cools.

If white spots remain, remove them with a

soap-filled scouring pad and rinse thoroughly

with a vinegar and water mixture.

These deposits are usually a salt residue that

cannot be removed by the clean cycle.

If the oven is not clean after one clean cycle,
repeat the cycle.

I You cannot set the oven for cooking until the

oven is cool enough for the door to unlock.

I While the oven is self-cleaning, you can

touch the CLOCK

pad to display the time

of day. To return to the clean countdown,

touch the COOKING TIME

pad.

I If the racks become hard to slide, apply a

small amount of vegetable oil or cooking oil to
a paper towel and wipe the edges of the oven

racks with the paper towel.

28

Advertising