GE C2S985SETSS - Manual (Page 39)

Installation Instructions
A
warning
INSTALLATION SAFETY
INSTRUCTIONS
Read these instructions completely and carefully.
Improper installation, adjustment, alteration, service
or maintenance can cause injury or property damage.
Refer to this manual. For assistance or additional
information, consult a qualified installer, service
agency, manufacturer (dealer) or the gas supplier.
Never reuse old flexible connectors. The use of old
flexible connectors con cause gas leaks and personal
injury. Always use NEW flexible connectors when
installing a gas appliance.
Leak testing of the appliance shall be conducted
according to the manufacturer instructions.
IMPORTANT
~ Remove all packing material
and literature from oven before connecting gas and
electrical supply to range.
A CAUTION
____________________ Do not attempt to operate
the oven of this range during a power failure (Electric
Ignition models only).
■ Have your range installed by a qualified installer.
■ Your range must be electrically grounded in
accordance with local codes or, in the absence of
local codes, in accordance with the National Electrical
Code (ANSI/NFPA 70, latest edition). In Canada,
electrical grounding must be in accordance with the
current CSA C22.1 Canadian Electrical Code Part 1
and/or local codes. See Electrical Connections in this
section.
■ Before installing your range on linoleum or any other
synthetic floor covering, make sure the floor covering
can withstand 180°F without shrinking, warping or
discoloring. Do not install the range over carpeting
unless a sheet of 1/4" thick plywood or similar
insulator is placed between the range and carpeting.
■ Make sure the wall coverings around the range can
withstand heat generated by the range up to 200°F.
■ Avoid placing cabinets above the range. To reduce
the hazard caused by reaching over the open flames
of operating burners, install a ventilation hood over
the range that projects forward at least 5" beyond
the front of the cabinets.
■ The ventilating hood must be constructed
of sheet metal not less than 0.0122" thick.
Install above the cooktop with a clearance of not
less than 1/4" between the hood and the underside
of the combustible material or metal cabinet. The
hood must be at least as wide as the appliance and
centered over the appliance. Clearance between the
cooking surface and the ventilation hood surface
MUST NEVER BE LESS THAN 24".
EXCEPTION: Installation of a listed microwave oven or
cooking appliance over the cooktop shall conform to
the installation instructions packed with that appliance.
■ If cabinets are placed above the range,
allow a minimum clearance of 30" between the
cooking surface and the bottom of unprotected
cabinets.
■ If a 30" clearance between cooking surface and
overhead combustible material or metal cabinets
cannot be maintained, protect the underside of the
cabinets above the cooktop with not less than 1/4"
insulating millboard covered with sheet metal not less
than 0.0122" thick. Clearance between the cooking
surface and protected cabinets MUST NEVER BE LESS
THAN 24".
■ The vertical distance from the plane of the cooking
surface to the bottom of adjacent overhead cabinets
extending closer than l"to the plane of the range
sides must not be less than 18". (See the Dimensions
and Clearances illustration in this section.)
■ Do not install this product with an air curtain hood or
other range hood that operates by blowing air down on
the cooktop. This airflow may interfere with operation of
the gas burners resulting in fire or explosion hazard.
ACAUTION
” Only the GE Café branded series
of Advantium® or microwave over-the-range ovens are
designed to be installed above the GE Café range. Surfaces
above a gas range can become hot. Installation of any other
over-the-range oven above a GE Café range may result in
surface temperatures that can cause burns.
39