Erasing one line, Notes, Relocation of the carrier – Brother WP330MDS User Manual
Page 120: Note, Manual corrections
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Erasing One Line
CODE
OUT^
LMEOUT
To erase an entire line, position the carrier to the right of the last character on the line
and press
CODE + LINE OUT.
The entire line is erased and you can retype.
NOTES:
*
Automatic erasing in progress can be stopped by pressing
CORRECT.
• Position the cursor to the space immediately to the right of the last character to be
erased while in centering, right margin flush, decimal tab, and LA. modes.
Congratulations on your purchase of this new word
Relocation of the Carrier
CODE
+
I
After a correction is made in the middle of the current line, pressing CODE + RELOC
moves the carrier to the position next to the last character.
NOTE:
Pressing CODE + RELOC moves the cursor to the space immediately to the right
of the last data while in the centering, right margin flush, decimal tab, and LA
modes.
Manual Corrections
When a correction is required above the current line, or if you have to reinsert the
paper, the memory correction does not work because the line memory is cleared each
time the paper is fed more than 1/12 inch.
NOTE:
This function cannot be executed while in the centering, right margin flush,
decimal tab or LA mode.
110