Brother WP330MDS - Manual (Page 50)

CODE + GO TO, then Function
T
Moves the cursor to the beginning of the current page;
moves to the beginning of the previous page when the
cursor is at the beginning of the current page.
J, Moves the cursor to the beginning of the next page.
<- Moves the cursor to the beginning of the document.
Moves the cursor to the end of the document.
Inserting Text
+
T1
k—^
I nsert J
Pressing CODE + I (INSERT) switches the word processor between insert and
ovenwrite modes, and turns the INS indicator on and off accordingly.
In overwrite mode (indicator INS off), each character you type replaces the current
character. You type over the existing data and your new data replaces the old data,
(Overwrite is the "default”. That is, every time power Is turned ON, the word processor
starts in Overwrite.)
In insert mode (indicator INS on), the characters you typo appear in front of the
cursor, the rest of the line automatically moves to the right and, if necessary, the last
word moves to the next line.
NOTE:
Since deleting unnecessary characters is usually easier than retyping characters
that have been deleted, it’s a good idea to make sure that the word processor is
in the insert mode before you start revising.
Deleting Text
You can delete text at four different levels:
• a character at a time
• a word at a time
• a line at a time
• a block at a time (See “Deleting a Block” on page 43.)
Whichever level you choose, the word processor automatically closes up the gap and
reformats the text to fit the margins and the page length.
40