File operation, Saving the framing file, Retrieving a framing file – Brother WP330MDS User Manual
Page 163: Printing framing files
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
File Operation
Saving the Framing File
as
When the frame is complete, press FILE and proceed to save or delete the framing
file as you would with a text file. (See “Saving a File” on page 73) The framing file will
be handled in the same way as ordinary text files. Framing files are given the file
name extension “.FRM”.
Retrieving a Framing File
ffilVRN
To edit an existing framing file (a file with the “.FRM” file name extension), select the
file on the FRAMING INDEX screen and press RETURN. The frame is displayed and
its file name appears at the upper-left corner of the screen.
Printing Framing Files
1. Proceed as you would with a text file. The following message appears:
Insert paper. Select pitch. Move carriage to starting position, press RETURN,
2
.
3.
4.
5.
Insert paper.
Use
CODE + PITCH
to select the pitch.
Use SPACE BAR, BACKSPACE, CODE + BACKSPACE, CODE + P UP, and
CODE + P DOWN to position the carriage on the paper at the point where you
want the frame to start (the upper-left corner of the frame).
Press RETURN. The following message appears:
Change to KB:I (or II, HI) 10 (or 12, 15) wheel and press RETURN.
NOTE:
You must use an International or Symbol daisy wheel and use the KB:U or KB:1U
setting to print double horizontal lines properly. If you try to print a frame with the
keyboard set to
I,
vertical lines will be printed using periods (.), and, double
horizontal lines will be printed as single lines.
153