Cisco 11500 Series - Manual (Page 52)

Chapter 1 Unpacking and Installing the CSS
Installing a CSS Module
1-24
Cisco 11500 Series Content Services Switch Hardware Installation Guide
78-13884-03
Unpacking a CSS Module
To unpack a CSS module:
1. Verify that the module is the model you ordered by checking the model
number listed on the side of the shipping carton.
2. Remove the module from the shipping carton, leaving it in its anti-static bag.
3. Put on the anti-static strap provided with your CSS. For example, wear the
anti-static wrist strap (included in the accessory kit) and stick the copper-tape
end of the strap to an unpainted metal surface on the chassis. Make sure that
the wrist strap makes good contact with your skin.
4. Remove the module from the anti-static shielding bag and inspect it for
damage.
Always hold the module by the faceplate, being careful not to touch the
components. If the module appears to be damaged, return it to the anti-static
bag, repack it in the shipping carton, and contact your local supplier.
5. To install a module into the CSS chassis, see “Installing a Module”.
Installing a Module
Caution You must power down the CSS before installing or removing a module in a
CSS 11506.