Cisco 11500 Series - Manual (Page 79)

2-23
Cisco 11500 Series Content Services Switch Hardware Installation Guide
78-13884-03
Chapter 2 Cabling the CSS
Connecting the Chassis to Ground
1 or 2 2-hole grounding lug. Lug must
fit 6 AWG stranded copper or
37/24 flex cables. Each lug must
have two holes, centered
0.625 in. (1.587 cm) apart, and
must accept M5 screws.
One lug is supplied by Cisco
Systems in the accessory kit. The
supplied lug is for the router end
of the ground wire. You may
wish to use a lug other than the
one supplied. If you need a lug
for the facility end of the ground
wire, you must supply it.
Recommended types:
• Panduit no. LCD6-10A-L
(1 supplied in accessory
kit)
• Panduit no. LCC6-10A-L
(long barrel)
• Thomas & Betts no.
256-30695-1183(*4*)
• Burndy no. YA6CL2TC10
1 Crimping tool Must fit diameter of grounding
lugs. Cisco Systems
recommends that you use a
crimping tool recommended by
the lug manufacturer.
2 M5 screws with captive, locking
washers Included in accessory kit
shipped with the CSS.
Table 2-8 Tools and Supplies (continued)
Quantity Description Comments