Paper roll replacement and other, Maintenance operations – Toshiba TEC MA-1060-100 Series User Manual
Page 112
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PAPER ROLL REPLACEMENT AND OTHER MAINTENANCE OPERATIONS
Paper End
INSTALLING THE RECEIPT PAPER
1. Turn the Mode Lock to the "REG" position.
2. Remove ' the Receipt Cover by pulling it
upward (Fig. 1).
3. Set the new paper roll in the receipt roll
holder with the paper end fed from the
bottom as shown in Fig. 2 (Fig. 3).
4. Insert the paper end into receipt inlet as
holding the |RF| key pushed down (Fig. 4).
5. When the paper comes out of the receipt
outlet for approx. 5cm (or 2 inches),
release the IRFI key (Fig. 5).
6. Attach the Receipt Cover. Meanwhile, the
paper end must be seen outside the cover.
7. Press the
key to clear the paper-end
condition, and depress the
\
NS | key and
cut the issued receipt to check if the
pa^prer“lra3' proper-ty■“S'ei:-... .... ....... ..—
REMOVING THE RECEIPT PAPER
1. Remove the Receipt Cover by pulling it
upward (Fig. 1).
2. Pull the Free Lever frontward while pull
ing the old paper core upward to remove
the remaining receipt paper tail (Fig. 6).
- 108 -