Toshiba TEC MA-1060-100 Series User Manual
Page 89
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SPECIAL CHARACTER GENERATION TABLE PROGRAMMING
This program Ls provided to prepare special characters to be used for
printing messages, etc. by each customer, adding them to the CHARACTER
eORE TABLE wjiich is shown on page 96 as those already available on this
ECR.
, Type of Characaters Programmable:
Regular-sized Characters or
Double-sized Characters
. Maximum Number of Characters:
30 (Regular-sized) or
10 (Double-sized)
. Character Codes Assigned for These Special Characters:
170
through
199
(Regular-sized)
254
through
263
(Double-sized)
After programming special characters, fill in the blank table attached
to the CHARACTER CODE TABLE on page 96 .
CONDITION:
Any time outside a sale
OPERATION:
Mode Lock: SET
i
Repeat for another character,
1
3 1
1@/F0R'|*-
I
Character Code
(170~199 for Regular-sized
254^263
for Double-sized )
Horizontal Dot
Address No.
1
st
I
Vertical Dot Position
No. Combination
m
(l~7 for regular-sized,
1~17 for double-sized)
(Combined Number of
1 ~ 7)
HI I
at
/
tl
I
Repeat for the next Horizontal Dot Address.
ENLARGED FIGURE OF DOT MATRIX COMPOSITION
Regular-sized Character
(Horizontal Dot Address No.),
Double-sized Character
1 2 3 4 5 0 7
n
T
(Vertical Dot Position
No.)
1 2 3 4 5 Ó 7
8
91011121314151617
TT
- 85 -