Toshiba TEC MA-1060-100 Series - Manual (Page 117)

The drawer opens automatica 1ly when a
registration is finalized. In the even
of a power failure or a trouble, however,
open the drawer in the following manner.
OPENING THE DRAWER
Insert- the Drawer Release Key into
Drawer Re lease Lock and turn the key
45 degress clockwise. (Fig. 23)
REMOVING THE DRAWER
the
by
1. Lift the drawer up and pull it out.
2. Then let it go down and pull it out again,
and it will be removed.
3. When getting back the drawer, fit its
rollers on the rails of the register and
push it all the way in. (Fig.24)
WHEN A POWER FAILURE OCCURS ...
If power failure occurs, all sales data stored in the memories are auto-
matically protected by the battery installed in the ECR. The battery is
rechargeable and it is recharged when the AC power returns. As the power
returns, the register revives to cont inue the work. However, please note
the following phenomena to occur on the register when the power is regained:
1. The printer will work to print the entered data without failure after
the power recovery, if any data was being printed. However, one
extra line may be fed on the power recovery depending on the power
failure timing.
When the power is restored, the register will display the last item
entered before the power failure if the item was entered through
a motorized key (such as I DEPT| , media keys, etc.). In this case,,
continue the registering operation. However, if the register
displays "FAIL" when the power is restored, it indicates that the
last item entry was not completed (i. e. , only numeric keys or a
declaration key such as | RTN MDSE | were operated but not any
motorized key). In this case, first depress the key to clear
the "FAIL" condition, and then do the registering operation again
from the numeric or declaration key entry. In the even of a power
failure and its recovery,
is handed to the customer.
be sure to check the receipt before it
- 1 1 3 -