Toshiba TEC MA-1060-100 Series - Manual (Page 96)

TAX TABLE PROGRAMMING
CONDITION: After Auto Reset and GT Reset
OPERATION: Mode Lock: SET
1) Tax 1 Full Breaks
max. amount non-taxable t x ï T ï ^
I max, amount for ifi tax levied j I TX1/ m I
I max, amount for tax levied] -»■ I TXl/Ml
Repeat until the "A" Break is enterd.
I
max, amount for tax levied! ITXl/Ml ... "A" Break
I ST] (to indicate the "A" Break entry)
[max, amount for N+l)z( tax levied I -» 1 TXTT m I
¡max, amount for N+2g( tax levied! ITXl/Mi
Repeat until the "B" Break is entered.
lAT/TLi (to end)
NOTE: The amount entry may be a maximum of 4~digit value i9999f^)
2) Tax 1 ”A” Break and % Rate Combination
First set the "A" Break following the same operation up to the "A"
Break entry and the \ ST] depression in the above "1) Tax 1 Full
Breaks".
¡TAX RATE applied when exceeding the "A" Break amount]
(Maximum 5 digits, up to 99*999^- Use the [T| key to enter decimal
portion, if any. Example: To set 5%, enter 5* To set 5*003^,
enter dt • The fraction of the amount resulting from this
% rate calculation will be rounded off.)
+
1AT/TLI (to end)
3) Tax 1 % Rate Only
|o ! I T V M l
[TAX rate ! -> rATytri
I
(The conditions of the rate are the same as
the above TAX RATE.)
- 92 -