Toshiba TEC MA-1060-100 Series User Manual

Page 15

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

PERCENT CHARGE KEY

This key is used to add a percentage rate to a sale. If the pre­

programmed

percentage

rate

is

to

be

added,

depress

the

[HI

key

without a prior numeric entry. If a rate different from the pre­

programmed

%

rate is to be added, enter the desired rate on the

numeric'" keyboard and then depress the

\ % ^ ■

I

key. (The manual rate

will take priority.)

To operate, depress the

\ % + \

key either immediately after a depart­

ment entry if only that item requires the percentage addition, or

after the FST i key if required on the total bill. The percentage

rate and the amount are printed and will be added to the sale total.

The percentage rate may be within the range from 0.001 to 99*999^*

The fraction resulted from the percentage calculation is usually

programmed to rounded off. However, it can be programmed to be

rounded up or discarded.

Usually, if the

\ % + \

key is depressed after a second [sfl key

depression within a sale, it adds the rate to the entire sale total.

However, it can be programmed to add the rate to the subtotal of the

items entered between the first and the second 1 ST| key depressions.

PERCENT DISCOUNT KEY

This key operates in the same fashion as the

El

key except that

operation will subtract from instead of adding to a sale.

[C]

CLEAR KEY

This key is used to correct a numeric entry error prior to depressing

any other key, or to correct any error condition and cancel the alarm

buzzer.

If the

key is depressed after a sub-total is obtained, the sub­

total is again displayed.

ITX/MI (for Single-tax Area)

|TXr/M|, 1TX2/MI (for Dual-tax Area)

TAX MODIFIER KEYS

Each of these keys is used to reverse the taxable/non-taxable status

on departments other tax-programmable keys for one entry only. For

dual-tax areas, two keys should be provided — jTX1/M| and ITX2/M[

— in place of the

I

TX/M

I

key for the single-tax areas. The two tax

modifier keys will function independently each with its own tax table

pre-programmed for taxable items.

The tax modifier key(s) will be effective to reverse the tax status

programmed on Department keys, jPOLL DISCl,

IBTL RTN!,

and PLUs.

T

o

operate, depress the 1TX/M| key prior to depressing any of these

function keys above listed, i.e., either before or after the amount

entry.

- 11 -

Advertising
This manual is related to the following products: