Toshiba TEC MA-1060-100 Series - Manual (Page 74)

4. When only the name is programmed or changed but not the status,
STEP (A) may be skipped in the above operation. Likewise, when
only the status is programmed or changed but not the name, STEP
(B) may l>e skipped.
5. Among JTX1/ m ! ( ITX/ m I ) . |TX2/M| . depress the key(s)
for the required status change(s) for each department. The |RTN
MDSE
I
is depressed to set or reset the negative department status.
6 . Depressing any of the three keys above, the related status
reverses. For example, depressing the ITX/MI reverses a non-
taxable department to a taxable, or taxable to non-taxable.
Each department status is read by the number indicated in the
AMOUNT portion of the display when each department key is
depressed in the above operation. The numbers and their
respective statuses are:
0: Non-taxable
1 : Tax 1 taxable only
2; Tax 2 taxable only
3; Tax 1 and Tax 2
both taxable
Lamp lit: negative
Lamp unlit:
positive
(This status is reversed
by the IRTN MDSEI key.)
Watching the number, adjust the status by depressing these keys.
See the examples below:
[STATUS NUMBER
BEFORE CHANGE
0
0
0
KEY-IN FOR CHANGE
PRIOR TO I Dept I KEY
llvTri
rtx1/MlITX2/MI
ITXI/MI
I' si T m I
NEW NUMBER ANDj
STATUS OBTAINED
l(Taxl only)
3(Taxl and Tax2)
5(Taxl and S.I.)
etc.
ITXI/Ml
rTX2/M I
ITXI/MIITX2/M1
0(Non-txbl)
3(Taxl and Tax2)
2(Tax2 only)
etc.
2 TX2/M
3 TXl/M TX2/M
0(Non-txbl)
0 (Non-txbl)
etc.
In order to simplify the status setting operation, each depart­
ment status may be reset to "0" by entering "0" and depressing
the department key. (This can only be done after Auto Reset,
GT Reset, and PLU Reset.) Then the required status is set simply
by depressing the keys ITXl/M i (ITX/MI).
only once.
and/or TX2/M
- 7 0 -