Clerk keys (1,2,3,4) – Toshiba TEC MA-1060-100 Series User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CLERK LOCKS
These
locks
are
used
to
identify
which clerk is operating the register.
Clerk Keys ( 1 , 2 , 3 , 4 )
Each
clerk
should
keep
his/her
clerk
key.
The
register will not operate unless one of these keys
is inserted and set to the corresponding position
on the Clerk Locks. Each of the keys may be inserted
and pulled out in the neutral position marked with
the (point).
GT LOCK
This lock is provided to read or reset the accumulated
sales totals not on the daily but on weekly or monthly
basis.
GTX Position:
This
position
allows
to
read
the
accumulated totals.
The GTX key as well as GTZ Key can
access this position.
GTZ Position:
This position allows to read and reset
the accumulated totals.
The GTZ
position.
Key only can access this
NOTE: When the GT Lock is turned to either the
GTX or GTZ position^ the Mode Lock position
or any Clerk Key ON/OFF condition will
be disregarded.
- 3 -