Toshiba TEC MA-1060-100 Series - Manual (Page 116)

Clean the slip detector when replacing the receipt roll, journal roll, or
ink ribbon.
If the slip detector has not been cleaned for a long period of time, the
cash register may fail to be registered on. In such a case, the "SLP" lamp
will keep lit on. This is the same state as a validation slip is inserted
because of paper dust deposited on the slip detector.
H How to Clean the Slip Detector
CLEANING THE SLIP DETECTOR
1. Turn off the
power switch,
(The power switch
is located on the
right side of the
register,)
Power Switch
Push
J
'2. Remove the ribbon
cover.
Ribbon Cover
The cover is unhooked
when slightly pushed
in the direction of
the arrow.
3. Open the cutter cover.
4. The slip detector is indicated by
the arrow. . _ journal
Receipt Ribbon
{
5, Clean the slip detector with
a brush.
Dot Head
If the dot head is located on the right
side of the machine, close the cutter
cover and turn the power ON, and the
dot head will move and stop on the
left side.
After cleaning, make sure that the
ink ribbon is properly mounted on
the ribbon guide.
6 . Close the ^ *"7, Turn on the power switch. Depress ^
%.
Install
cutter cover. NOTES: the NS ribbon
(Securely 1. If the display is blinking key to cover.
hook the it indicates that the issue a
cover on the cutter cover is not pro- receipt.
left side.) perly closed. Securely Check that
close the cover. the
2. Depress the key. receipt is
The display should turn printed
lit. normally.
------ -------- V_____________________________ J 1 ____________J __________
- 112