Toshiba TEC MA-1060-100 Series User Manual
Page 114
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
u
CC
When the receipt and journal print is too
light,
replace
the
ink
ribbon
in
the
following manner.
Removing the Ribbon
1. Turn the Power Switch to OFF.
2. Remove the Ribbon Cover.
Press the side
inward and the hook will unlocked (Fig.14).
3. Open the Cutter Block by pulling it upward
while pressing the leftside lever outward.
(Fig. 15 and Fig. 16)
4. Remove the Ink Ribbon by lifting up the
ribbon spools (Fig. 17).
Installing the Ribbon
1. Set the ribbon spools so that the ribbon
will be wound to the directions shown by
the arrows respectively. Meanwhile, let
.. --t-he—.rih-ban._gn_.„through .__th.e..... Ri.hhnn..... Guides ,
the Tension, arid the Dot Head Ribbon Guide
(Fig.18 and Fig,19).
2. After setting, make sure that the ribbon
properly goes through each required parts
by turning a ribbon spool several turns.
3. Close the Cutter Block. Make sure that
the leftside lever has locked the block.
4. Turn the Power Switch to ON.
5. Depress
key. The flashing display
will stop and be lit steadily.
6. Attach the Ribbon Cover,
REPLACING THE INK RIBBON
R i bbon
F i g , 1 8
- 110 ~