Toshiba TEC MA-1060-100 Series User Manual
Page 113
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
F i g . 7
-F4-g-.-8-
1. Turn the Mode Lock to the "REG" position.
2. Remove the Receipt Cover by pulling it
upward (Fig. 1 on the previous page).
3. Remove the Journal Winding Reel.
4. Setthe new paper roll in the journal roll
holder (righthand side) with the paper
end from the bottom (Fig. 7),
5. Insert the paper end into the journal
inlet while holding the | JF | key pushed
down (Fig. 8).
6. When the paper comes out of the journal
outlet for approx 20cm (or 8 inches),
release the |JF| key (Fig. 9).
7. Wind up the paper end on the Journal Wind
ing Reel two or three times as shown in
Fig. 10.
8. Set the Journal Winding Reel to the holder
(Fig. 11).
9. Attach the Receipt Cover (Fig, 12).
10. Depress
key before starting operations.
INSTALLING THE JOURNAL PAPER
REMOVING THE JOURNAL PAPER
1, Remove the Receipt Cover by pulling it
upward (Fig, 1 on the previous page),
2, Depress I'
j
'
f
'I key to wind up enough portion
of the journal paper, and then tear off
the paper, holding the Journal Winding
Shaft.
3. The wound-up portion of the paper can
easily be removed from the Winding Shaft
by pulling it side way (Fig. 13).
4. If enough paper remains on the roll,
follow Steps 6 through 10; if paper is
running out, follow Steps 1 through 10
in "INSTALLING THE JOURNAL PAPER" above.
- 1 0 9 -