Toshiba TEC MA-1060-100 Series - Manual (Page 59)

CONDITION: After Auto Reset and GT Reset
OPERATION: Mo^e Lock: BLIND or SET
SYSTEM OPTION PROGRAMMING
Mode Lock: SET 111 I@7 for I
(or 1T| )
Address No.
( 1 ~ 1 1 )
Bit Nosl
^[¥]
IAT/TLi
Enter a maximum of eight-digit number composed of Bit Nos whose
status must be set to the "SET" status. If there is no Bit No.
to be set to the "SET" status in an Address No., enter "0".
ex.) To set Bit No.2 only .......... Enter 2.
To set Bits No.2 and No.3 •••• Enter 23.
To set all the Bit Nos ........ Enter 12345678.
To reset all the Bit Nos ...... Enter 0.
NOTES: 1. Any Bit No. with the "—vacant—" item will be disregarded even
if it is set. (However, if ever set, it will not result in an
error.)
2. When the product is delivered to the customer, each Address #
has already been set with proper Options Nos according to the
customer's requirements. Therefore, it is recommended to read
out the programmed data of the SYSTEM OPTION first (refer to
page 117 ) and next do this programming operation only for the
Addresses that require option change.
ex.) To set the following options:
Address #1 Table (refer to the next page.)
Bit N 0 . 1 Time NON-PRINT (SET status)
N 0.3 Sub-total NON-PRINT (SET status)
Other Bit Nos will be selected to "RESET"
status:
Mode Lock to SET, enter 11, depress |@/F0Rl.
Enter 1 (Address No.), depress ___ _
Enter 13 (Option Nos for SET), depress [^|
Depress |AT/TL| to end.
- 5 5 -