Toshiba TEC MA-1060-100 Series - Manual (Page 73)

CONDITION: To change the Department Name only: Any time outside a sale
To change the Department Tax Status: After Auto Reset
To change the Department Positive/Negative Status:
After an Auto Reset,
GT Reset, and PLU Reset
DEPARTMENT NAME AND STATUS PROGRAMMING OR CHANGING
OPERATION: Mode Lock: SET
3l I@/FORI
(or [T| ) A
(iWMl)
for tax status
change in single-
tax area
-K iTXl/MI ) -» { ITX2/MI)-»
for tax 1 for Tax 2
status status
change change
M iRTN MDSE I)--
for negative/
positive status
change
in dual-tax area
STEP (A); Status Change
r
1
(I SHIFT I) for shifted
I Departments only
Department
Repeat for the next character.
regular-sized|p
character
____1@/ for 1____
one double-sized
character
I@/ for | 1@7 for ~I
■^1 Character Code | -^IW \
(2 or 3 digits
see the table
on page 96 .)
^|AT/TL|
for spacing instead
of a character
Entire name with
all double-sized
characters
to end the DP Name
(If any space is
left unprogrammed
in the tail, it
will automatically
be programmed as
space.)
STEP (B): Name Change
NOTES: 1, The "[Department 1" is the Department Key whose status or name
should be changed or programmed in this operation. The
1
SHIFT
i
and
I
Department
I
depressions will result in operating the shifted
department. For example,
I
SHIFT| and iDept. H will be |Dept.3T| .
2. The [S hey after the Character Code entry may be replaced by
the I#/C1D1 or l#/NSi key.
3. For the name of a department, a maximum of 6 regular-sized
characters or 3 double-sized characters may be entered. A combi­
nation of both types is also available.
- 69 -