Toshiba TEC MA-1100-400 SERIES - Manual (Page 107)

CONDITION: After Auto Reset and GT Reset
OPERATION: Mode Lock: SET
TAX TABLE PROGRAMMING
1) Tax 1 Full Breaks
max. amount non-taxable
I max, amount for Ifii tax levied | 1 TXl/M 1
[max, amount for 2^ tax levied| -*• I TXl/Mi
Repeat until the "A" Break is enterd.
I max, amount for N^ tax levied 1 ITXl/M1 ... "A" Break
I ST I (to indicate the "A" Break entry)
I max, amount for N+l);( tax levied] fTXl/Ml
I max, amount for N+2)z( tax levied 1 -> 1 TX17 m I
Repeat until the "B" Break is entered.
IAT/TLI (to end)
NOTE: The amount entry may be a maximum of 4-digit value (9999fi^) *
2) Tax 1 "A” Break and % Rate Combination
First set the "A” Break following the same operation up to the "A"
Break entry and the 1ST I depression in the above "1) Tax 1 Full
Breaks".
i
I TAX RATE applied when exceeding the "A" Break amount]
(Maximum 5 digits, up to 99-999^- Use the Q key to enter decimal
portion, if any. Example: To set 5%, enter 5* To set 5*003^,
enter 5 - ^ [ Z I ■ The fraction of the amount resulting from this
% rate calculation will be rounded off.)
+
lAT/TLl (to end)
3) Tax 1
%
Rate Only
|0l IW m I ^ [H] [TAX rate ! -> ÎAT/TLl
(The conditions of the rate are the same as
the above TAX RATE.)
- 103 -