Toshiba TEC MA-1100-400 SERIES - Manual (Page 82)

4. When only the name is programmed or changed but not the status,
STEP (A) may be skipped in the above operation. Likewise, when
only the status is programmed or changed but not the name, STEP
(B) may be skipped.
5. Among ITXI/ m I (I tx / m I). ITX2/ m 1, and ISl/M|, depress the key(s)
for the required status change(s) for each department. The IRTN
MDSE I is depressed to set or reset the negative department status,
6. Depressing any of the three keys above, the related status
reverses. For example, depressing the ITX/M| reverses a non-
taxable department to a taxable, or taxable to non-taxable.
Each department status is read by the number indicated in the
AMOUNT portion of the display when each department key is
depressed in the above operation. The numbers and their
respective statuses are:
0:
1 :
2:
3:
5:
6 :
7:
Non-taxable
Tax 1 taxable only
Tax 2 taxable only
Tax 1 and Tax 2
both taxable
S.I. only
Tax 1 and S.I.
Tax 2 and S.I.
Tax 1 and Tax- 2 and S.I.
Lamp lit: negative
Lamp unlit:
positive
(This status is reversed
by the iRTN MDSE| key.)
Watching the number, adjust the status by depressing these keys.
See the examples below:
[STATUS NUMBER
BEFORE CHANGE
0
0
0
KEY-IN FOR CHANGE
PRIOR TO I Dept I KEY
i'fxTMl
ITX1/Ml ITX2/MI
NEW NUMBER AND|
STATUS OBTAINED
iTxi/Ml IW m I
l(Taxl only)
3(Taxl and Tax2)
5(Taxi and S.I.)
etc.
iTXl/Ml
1TX2/M1
ITXI/MIITX2/MI
0(Non-txbl, no S.I.)
3(Taxl and Tax2)
2(Tax2 only)
etc.
I TX2/M1
isfm\
6(Tax2 and S.I.)
3(Taxl and Tax2)
etc.
In order to simplify the status setting operation, each depart­
ment status may be reset to "0” by entering "0" and depressing
the department key. (This can only be done after Auto Reset,
GT Reset, and PLU Reset.) Then the required status is set simply
by depressing the keys ITXl/Mi (ITX/MI). i TX2/MI, and/or ISI/M|,
only once.
- 78 -