Toshiba TEC MA-1100-400 SERIES - Manual (Page 91)

FINAKCIAL TOTAL NAME PROGRAMMING OR CHANGING
CONDITION; After Auto Reset and GT Reset
OPERATION: Mode Lock; SET
9l l@/F0Rl(orrri ) I Code for the Total Item]
(See the table on the
next page.)
Repeat for another Item.
Repeat for the next character
regular-sized f
character
--- |@/FOR|___
One double-sized
character
t@/F0R| I@/FORI---
Entire name with
all double-sized
characters
for spacing instead
of a character
f
-»I Character Code II STj
(2 or 3 digits; ^
see the table
on page 113.)
Repeat
for the
next
sequencial
coded item
^lAT/TL|
to end the name
(If any space is left
unprogrammed in the
tail, it will auto­
matically be program­
med as space.)
NOTES: 1. A maximum of 6 regular-sized characters or 3 double-sized charac­
ters may be programmed for one item name, with some exceptions.
A combination of two types is also available.
2. To go on to another Item name programming, the sequence " |Code
for the Total Itemlis^'* may be skipped if the code is sequencial.
ex.) To program "PO" in double-sized characters
instead of ’*P0" in regular-sized characters
(Standard : Program Data) for Item No.21 (Paid Out);
Mode Lock to SET, enterrf, depress |@/FORi .
Enter 21, depress I ST I (Item Code for Paid
Depress Out),
I@/FORI twice (for declaration of
entire name with double­
sized characters)
Enter 26, depress [1]. (P)
Enter 25, depress . (O)
Depress I S T I to end this name.
Depress 1AT/TL! to end this program.
TEC STORE
1343 PEACH DRIVE
PHONE! 877-A437
Thank you
Cau again
09-16-83 «0
P 09
tt21
PO
0020 13!48TM
- 87 -