Cleaning the slip detector – Toshiba TEC MA-1100-400 SERIES User Manual
Page 136
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CLEANING THE SLIP DETECTOR
Cleaning the slip detector when replacing the receipt, journal, or ink ribbon.
If the slip detector has not been cleaned for long periods, the cash register
may fail to be registered on. In such a case, the "slip lamp” will be kept
on- This is the same state as when a slip is inserted because of paper dust
deposited on the slip detector.
How to Clean the Slip Detector
1. Turn off the
power switch.
(The power switch
is located on the
right side of the
register.)
Power Switch
Push
L
^
2
. Remove the ribbon
cover.
Ribbon Cover
The cover is unhooked
when slightly pushed
in the direction of
the arrow.
4. The slip detector is indicated by
the arrow.
, _ journal
Receipt
Ribbon
Dot Head
If the dot head is located on the right
side of the machine, close the cutter
cover and turn the power ON, and the
dot head will move and stop on the
left side.
5. Clean the slip detector with
a brush.
After cleaning, make sure that the
ink ribbon is properly mounted on
the ribbon guide.
Close the ''
"^7. Turn on the power switch. ''
^8. Depress ^
cutter cover.
NOTES:
the rNS"
(Securely
1. If the display is blinking
key to
hook the
it indicates that the
issue a
cover on the
cutter cover is not pro-
receipt.
left side.)
perly closed. Securely
Check that
close the cover.
the
2. Depress the key.
receipt is
The display should turn
printed
lit.
normally.
------------
J
1
_______________
9, Install the
ribbon
cover,