Toshiba TEC MA-1100-400 SERIES - Manual (Page 26)

RECEIPT
ISSUE
RECEIPT POST-ISSUE KEY
This key is used to issue the receipt of a sale (prints the sale total
only, not detail items) when the sale has already been finalized with
the [RECEIPT ON/OFF] switch positined to OFF.
To operate, depress the [RECEIPT ISSUE] key without numeric entry.
The receipt for the last sale is then issued. This key will not
function if another sale has already been under way.
Single-item Department Keys
Two ways are available for changing ordinary department keys into
Single-item Department keys. One is to change Departments 1 through
30 only into Single-item Keys and to hold other Departments as
as
ordinary department keys. The other is to change all the
Departments (maximum 60 departments) into Single-item Keys.
If a department is programmed as a Single-item Key, the department
entry routine will immediately finalize the sale as cash without
operating any of the media keys when operated outside a sale. The
Single-item Key will function, however, just as an ordinary itemized
department key if used inside a sale.
TAX MANUAL TAX KEY
This key is used to enter an irregular tax amount that cannot be
calculated on the basis of the programmed tax table, and to add it
to the sale total.
To operate, enter the desired amount of tax, and then depress the
I TAX [ key. The tax amount entered is then printed. This tax amount
is processed into the TAX 2 memory. Therefore, the tax amount auto­
matically calculated and printed at finalizing the sale (TAX 1) does
not include a manual-entered tax, while the entire sale total printed
on the receipt last line includes the manual-entered tax also.
This key is also used, if depressed without an amount entry within
a sale, to display the total of only non-taxable items so far entered.
Usually, this non-taxable total is only displayed but not printed.
However, it may be programmed to print also.
I ITEM CORRl ITEM CORRECT KEY
This key functions as Item Correct key (but not as Designated Void
key), which has already been described for the IIC/VDl key.
1VOID I DESIGNATED VOID KEY
This key is used as Designated Line Void key (but not as Item Correct
key), which has already been described for the IIC/VDI key.
- 22 -