Toshiba TEC MA-1100-400 SERIES - Manual (Page 128)

CUTTER BLOCK OPEN DETECTOR AND PAPER NEAR-END DETECTOR
1. CUTTER BLOCK OPEN DETECTOR
(1) This detects when the Cutter Block of the Printer is opened. It
is provided in order to protect your hands and fingers from injury
and also to protect the printer itself.
(2) While the Block is opened, none of the keys (including | RF | and
will be accepted and the AMOUNT portion of the display will
keep flashing.
(3) When the Block is closed and the key is depressed, the display
flashing will be cleared and key-ln operations will be accepted.
If the Block was opened during printing, the suspended printing
will be started again.
(4) If the Block is opened during printing, the printing will
Immediately be stopped.
2. JOURNAL AND RECEIPT PAPER NEAR-END DETECTOR
(1) This detects when either the journa1 or receipt paper is coming
near the end. It is provided in order to prompt the operator
to replace the old paper roll with a new one.
(2) When the paper roll comes near the end (or the paper has not been
set properly), no key operation (except [RF| and 1JFI) will be
accepted and the AMOUNT portion of the display will keep flashing.
(3) When a new paper roll is set, only the | RF | and | JF | keys are
allowed to operate. Next, when the key is depressed, the
display flashing will be cleared and norma 1 key-in operations
will be accepted. If any printing was suspended, it will continue
print ing.
(4) If this detector sensed a paper near-end condition during printing,
printer will stop after the current line printing is completed.
(5) The I RF I an d [JF] keys are operative regardless of the detector
ON/OFF condition.
(6) If the 1^ key is depressed in the the paper-end condition, it
will be ignored. The key depression will be effective to
clear the display flashing only after the new paper roll is set.
- 124 -