Toshiba TEC MA-1100-400 SERIES - Manual (Page 7)

CLERK LOCKS
Lock-and-Key Type (Standard)
1 . 2 3 . A
These locks are used to identify
which clerk is operating the register.
Clerk Keys (CLl, CL2, CL3, CL4)
Each clerk should keep his/her clerk key. The
register will not operate unless one of these keys
is inserted and set to the corresponding position
on the Clerk Locks. Each of the keys may be inserted
and pulled out in the neutral position marked with
the "." (point).
Push-key Type (Alternative Option, for ten clerks)
1-1 i H 3 I 4 I 5 I
r 6 I 7 I 8 I 9 I 10 I
This type may be installed in place
of the Clerk Locks above, as an
alternative option. In that case,
ten clerk keys will be installed.
Each clerk is assigned to his/her
own clerk key (1 through 10), The
register will not operate unless one
of these keys is pushed to stay down.
GT LOCK This lock is provided to read or reset the accumulated
sales totals not on the daily but on weekly or monthly
basis.
GTX Position:
This position allows to read the
accumulated totals.
The GTX key as well as GTZ Key can
access this position.
GTZ Position:
This position allows to read and reset
the accumulated totals.
The GTZ Key only can access this
position.
NOTE: When the GT Lock is turned to either the
GTX or GTZ position, the Mode Lock position
or any Clerk Key ON/OFF condition will
be disregarded.
- 3