Toshiba TEC MA-1100-400 SERIES - Manual (Page 15)

DOLL
DISC
DOLLAR DISCOUNT KEY
This key is used to subtract an amount from the sale total such as
a discount during a sale. An amount exceeding the sale total cannot
normally be entered. However, when the ’’Credit Balance” option has
been selected, over-subtraction of the sale total using this key is
allowed.
To operate, enter the discount amount on the numeric keyboard, and
then depress the |DOLL DISCl key.
PERCENT CHARGE KEY
This key is used to add a percentage rate to a sale. If the pre­
programmed percentage rate is to be added, depress the |%+1 key
without a prior numeric entry. If a rate different from the pre­
programmed
%
rate is to be added, enter the desired rate on the
numeric keyboard and then depress the \%+1 key. (The manual rate
will take priority.)
To operate, depress the key either immediately after a depart­
ment entry if only that item requires the percentage addition, or
after the FSTI key if required on the total bill. The percentage
rate and the amount are printed and will be added to the sale total.
The percentage rate may be within the range from 0,001 to 99*999^•
The fraction resulted from the percentage calculation is usually
programmed to rounded off. However, it can be programmed to be
rounded up or discarded.
Usually, if the |%+1 key is depressed after a second [ ST | key
depression within a sale, it adds the rate to the entire sale total.
However, it can be programmed to add the rate to the subtotal of the
items entered between the first and the second fST] key depressions.
[13 PERCENT DISCOUNT KEY
This key operates in the same fashion as the I %+1 key except that
operation will subtract from instead of adding to a sale.
E]
CLEAK KEY
This key is used to correct a numeric entry error prior to depressing
any other key, or to correct any error condition and cancel the alarm
buzzer.
If the [3 key is depressed after a sub-total is obtained, the sub­
total is again displayed.
- 11 -