FingerTec Q2 - Manual (Page 46)

45
Comm Opt u
4RS232 Yes
RS485
Yes
Note
When RS232 function
is enabled, the Ether-
net will be disabled.
Comm Opt u
4
RS232 Yes
4RS485 Yes
Note
When RS485 func-
tion is enabled, the
Ethernet will be
disabled.
Note
The RS232/ 485
converter is an op-
tional component.
Q2 Reader C2 Controller RS232 cable PC
RS232 Connection
1. Setup of RS232
Access to Menu, select “Options” > “Comm. Opt” > “RS232”, select
“Yes” to enable RS232 function.
2. Turn off the reader.
3. Plug the RS232 cable to the RS232 port of the PC.
4. Plug the RS232 other end to the RS232 joint.
5. Turn the power on.
RS485 Single Connection
1. Setup of RS485
Access Menu, select “Options” > “Comm. Opt”
> “RS485”, select “Yes” to enable RS485
function.
2. Turn off the reader.
3. Plug the RS485 cable extender to the connector. Connect another
end of the cable to the RS232/485 data converter.
4. Connect the RS485 data converter to the RS232 port of PC.
5. Turn the power on.