FingerTec i-Kiosk 100 Manual - Manual (Page 8)

8 CONTENTS
3 • USER
Enrolling User
The i-Kiosk 100 can enroll up to 10000 fingerprint templates, 10000 passwords (1
password per user) and 10000 card information templates. This chapter covers all
possible user enrollments in the terminals.
FINGERPRINT ENROLLMENT
It is recommended to enroll two fingerprints for one user ID. One template is used
as the default and the other one as a backup. You need to check the quality of the
fingerprint before doing any fingerprint enrollment. It is important to locate the
center points of the finger because the center points have to be placed in the mid-
dle of the scanner during enrollment to get a good reading. You also have to make
sure that the fingers are not too wet or too dry for enrollment.
To enroll fi ngerprint:
Press Menu > User icon > New User > User ID: (insert value) > Select “Enroll FP” >
Place your fingerprint 3 times following instructions given by the terminal > Select
Auth > OK to save.
CARD ENROLLMENT
The default card for the i-Kiosk 100 is RFID. MiFare and HID card systems are avail-
able upon request.
To enroll card: Press Menu > User icon > New User > User ID:1 >
Insert User ID > Select “Enroll Card” > Wave the card at the scanning area until the
screen displays the Card ID > OK to save.
PASSWORD ENROLLMENT
The i-Kiosk 100 offers different enrolment methods and password verification can
be used alone or in combination with other verification methods. The maximum
length of a password is 8 digits.
To enroll password: Press Menu > User icon > New
User > User ID: (insert value) > Select “Enroll Pwd” > Input password using the key-
pad > Reconfirm password > OK > OK to save.
Verifying User
1:1 (ONE TO ONE) / 1:N (ONE TO MANY)
VERIFICATION METHOD PROCESS
1:1 (One to One) You have to identify your User ID before inputting any biomet-
rics feature for verification. For example, your user ID is 1008.
One to one method requires you to key in user ID followed by
your fingerprint to get verified.
1:N (One to Many) You don’t need to identify your User ID before inputting any
biometrics feature for verification. Simply place your finger on
the scanner for verification.