FingerTec Face ID 4 Installation Guide - Manual

Back Plate
4 feet / 1.2 meter
(recommended)
s u p p o r t @ f i n g e r t e c . c o m
Face Recognition System for
Time Attendance and Access Control*
Series
Face ID 4
Face ID4 d
Step 1
Determine the Location and Positioning
of the Installation
•
Avoid installing the terminals in locations that has contact with
a strong light source (e.g direct sunlight, spotlight, fluorescent
light, etc)
•
Avoid installing the terminals in locations with high moisture or
condensation levels in the air.
•
The recommended installation height of the terminal from the
ground is 1.2 meters.
Step 2
Mounting of Terminals on a Wall
•
After determining the height of the terminal from the ground
level and have made the relevant marks on the wall, drill the
screws into the wall to fix the back plate.
Refer to Appendix II for dimensions and measurements of instal-
lation.
Installation Guide
w w w . f i n g e r t e c . c o m
INSTALLATION TIPS:
A good installation location of Face ID 4 must
1 - Avoid sunlight.
2 - Be 2 meters away from any light source e.g.
ceiling direct flourescent light
3 - Suggested 1.2m from the ground level (meas-
ure from ground to the camera)
Step 3
Wiring for Power Supply
Connection points for power and communication are available at
the back of the terminal. Refer to the following diagrams for the
correct installation.
Only available
for Face ID 4d
DC12V 3A
Power Supply
TCP/IP Port
TCP/IP
POWER SUPPLY (A)
DC12V 3A
Power Supply
GND
+12V
Alarm Output
Door Lock
System