FingerTec Face ID 4 Installation Guide - Manual (Page 2)

Diagram1 • Normally Close (NC)
Diagram 2 • Normally Open (NO)
Step 4
Setting Up Data Communication
(Skip this step if you are using USB fl ash disk to transfer data)
The data communication ports are positioned at the rear of the
terminals, please refer to the diagrams shown on Step 3 to deter-
mine the wiring. Plug the jacks (RJ45) to the ports.
TCP/IP – LAN Connection
For TCP/IP connection, plug the RJ45 jack into the TCP/IP (LAN)
port of the terminal. Connect the other end (normal RJ45 jack) to
the local area network hub or a PC. Configure the device ID, IP ad-
dress, subnet mask and Gateway in the terminal (refer to the hard-
ware user manual for details).
Step 5
Finalizing the Installation
1. Check that all cable connections are done correctly.
2. Attach the terminal to the corresponding back plates,
tighten the screws to secure the terminal on the wall
3. Switch on the power to the terminal.
4. Start using the terminal.
Other Accessories
Note: All accessories are offered at http://accessory.fingertec.com
AdapTec Plus
The AdapTec Plus is a 12VDC power supply inclusive of a
110~240VAC switching linear power. The AdapTec Plus supplies
12VDC power to the FingerTec terminal and door lock system as
well as charges a 12VDC 7.0Ah backup battery simultaneously.
During an event of a power failure, the back up battery automati-
cally provides power to the terminal and maintains the door lock
system. The AdapTec Plus also prevents a secured door from being
opened if it has been tampered with.
Door Lock Accessories
FingerTec offers various door locks accessories to complement
FingerTec door access product range. Go to
http://accessory.fin-
gertec.com to view the complete list.
Appendix I
Power Supply & Door Lock System
Wiring Diagrams
2
3
A
C
EM Lock
(NC)
Emergency
Break Glass
(NC)
Override
Key Switch
(NC)
Release
Button
GND 12V NC1 COM1 NO1
SEN GND BUT NO2 COM2 NC2
DC12V 3A
+
+
Alarm Device
(NC)
Alarm Device
(NO)
Door
Sensor
2
3
A
C
EM Lock
(NO)
Emergency
Break Glass
(NO)
Override
Key Switch
(NO)
Release
Button
GND 12V NC1 COM1 NO1
SEN GND BUT NO2 COM2 NC2
DC12V 3A
+
+
Alarm Device
(NC)
Alarm Device
(NO)
Door
Sensor