FingerTec AdapTec Plus - Manual (Page 13)

13
AdapTec Plus
Access Control/Power Output Module
To Battery Tamper Siren EM Output Siren Door Wiegand
Switch Output 12V Voltage Accept Exit Input
- + Input 12V 0V GND WD0 WD1
DC 12V
Rechargeable
Backup
Battery
Connection
Points
GND
PWR
AL+
AL
_
Release
Button
Alam
Siren
+ _
AdapTec Plus
Access Control/Power Output Module
To Battery Tamper Siren EM Output Siren Door Wiegand
Switch Output 12V Voltage Accept Exit Input
- + Input 12V 0V GND WD0 WD1
DC 12V
Rechargeable
Backup
Battery
Connection
Points
Release
Button
Alam
Siren
+ _
COM2
NC2 GND +12V
FUNCTION • AC900
For AC900, you will need to connect AC900, alarm siren and AdapTec Plus
as below.
FUNCTION • Face ID 2, i-Kiosk 100, Q2i, i-Kiosk 100 Plus
For Face ID 2, you will need to connect to alarm siren and AdapTec Plus
as below.
Reminder to deactivate alarm siren:
1. You can deactivate the alarm siren by pressing the push button that is connected to Siren
Accept in the AdapTec Plus. This action will turn off the alarm siren function in AdapTec
plus. However, you must restart the AdapTec Plus to turn on the alarm siren function
again. The alarm siren will not take effect in the future if you do not restart the AdapTec
Plus.
2. You can do it from the terminal via Menu > Turn Off Alarm to turn off the alarm siren. You
do not need to restart the AdapTec Plus. The alarm siren will return to standby mode after
you perform the steps at the reader. (Recommended)