Mounting an adaptec plus onto a wall 1 2 4 – FingerTec AdapTec Plus User Manual
Page 20
INPUT
: AC 110 ~ 240V
OUTPUT : DC 12V 3A
MOUNTING AN ADAPTEC PLUS
ONTO A WALL
1
2
4
After removing the piece, you will have
one L-shape piece and 2 screws.
3
Remove the L-shape piece from the AdapTec plus
Find an L-shape piece at the top right of an
AdapTec Plus. This piece is attached to the
AdapTec Plus with 2 screws.
Attach the L-shape to the AdapTec Plus
as shown and tighten the screws.
Open the cap, look for the part shown in
the diagram and you will see 2 holes.
www.fingertec.com
© 2011 FingerTec Worldwide Sdn. Bhd. All rights reserved. • Printed in Malaysia. 102011
Install the piece to the AdapTec Plus
The other 2 holes at the bottom
Mount the AdapTec Plus on a wall
Identify a location to mount the
AdapTec Plus on a wall.
Fix the AdapTec Plus onto the wall
by tightening the screws into the 4
holes.