FingerTec AdapTec TA - Manual

w w w . f i n g e r t e c . c o m w w w . f i n g e r t e c . c o m
Installer Guide
UNDERSTANDING ADAPTEC TA FUNCTIONS
• To support FingerTec terminals that are dedicated to Time Attendance
• To support rechargeable backup battery (compatible with any DC12V Rechargeable Backup
battery) and to act as a backup power supply during power failure
• To support DC12V Siren, maximum 1A. (For TA100 series only)
UNDERSTANDING THE TECHNICAL SPECIFICATIONS
Dimension (mm) 198 (L) x 131 (W) x 43 (H)
Weight 900g
Input Voltage AC 110 / 240 V (universal input)
Output Voltage DC 5V 1A and 12V 1A
Siren Output DC12V, max 1A
UNDERSTANDING THE DESIGN
© 2013 FingerTec Worldwide Sdn. Bhd. All rights reserved • 022013
1
2
3
1
3 4
6
5
2
The AdapTec TA is a power supply specially designed for FingerTec terminals for time and attendance
systems, including TA100 black and white series, TA100C series, AC100 series, and TimeLine 100 series
(which require DC 5V 1A). The AdapTec TA is intended to ease installation, to provide power supply and
to provide longer standby time during a power failure, supported by a DC12V rechargable battery.
AdapTec TA is compatible with all DC12V rechargable batteries in the market. The AdapTec TA consists
of a power supply or a power input module as well as a power output module. The AdapTec TA also
connects to other devices, which require similar power requirement of DC 5V 1A.
Note: Kindly seek FingerTec’s confirmation on device specifications via email to [email protected]
The AdapTec TA consists of 2 main modules:
Power supply/power input module.
Power output module.
POWER SUPPLY/POWER INPUT MODULE
This portion is to be connected to a power source with AC110~240V. An AC current will be
supplied into this side and a DC12V 3A current will be generated as output.
These two cables, -V and +V are defaults and connected to the inner part of AdapTec. Please
do not remove or replace these cables.
POWER OUTPUT MODULE
This LED is an indicator to indicate the output is available. Please return the unit if the LED
does not light up after it is powered on.
These are the power outputs from the AdapTec TA. FingerTec terminals and sirens will use
these outputs. Please refer to the wiring diagram for more details.
1
2
3
4
5
6