GTCO 2500 Series - Users Guide 3/3 - Manual (Page 11)

2500 Series 11
EXAMPLE:
To change the Run mode character to the new character “&” and leave all others at their
default values, enter the following command:
Host = ESC % G A A I P U & CR
Menu = [SET CHAR CONST] [A] [A] [I] [P] [U] [&] [CR]
The characters that came before (those in lower positions than) the Run mode character
were reassigned their same values; the new Run mode character is the last character
entered. All characters coming later (those in higher positions) remain unchanged.
Send Tablet Size
The tablet sends a coordinate pair representing the distance between the upper right
corner of the tablet and origin. The data represents the distance, in inches or millimeters,
multiplied by the current resolution in lines per inch or millimeter.
Host = ESC % V S CR
Menu = [SYSTEM FUNC 1] [S] [CR]
Communication Commands
The commands that follow are used to control communication between the tablet, host
and operator. They control the host display screen, tablet LED display, cursor LED’s, data
output from the tablet and messages from the large menu to the host.
Enable/Disable Output Port
This command allows you to control output from the RS-232C port. The command affects
only digitizer data output. Incoming commands from the host are not affected.
Host = ESC % a (b) CR
Cursor = FF a (b) E
Menu = [ENABLE/DISABLE I/O PORT A] (b) [CR]
Menu = [ENABLE/DISABLE I/O PORT B] (b) [CR]